Dranetz Visa Guía de usuario descargar pdf (Pagina 125)

6-11

CH 6/ Advanced Setup Options

Procedure to

record rms

variation

(continued)

Continued on next page

Action... Result...

STEP 3: Users can define the number

of rms summary and waveform

cycles to be saved before the start

(pre-), after the start (post-start), and

after the end (post-end) of the event.

The Pre- and Post- trigger settings

under Waveform Capture (Cycles)

specify the number of waveform

cycles to record before, during, and

after the event. Although waveform

cycle recording is enabled by default,

users have the option not to record

waveform cycles.

• Press Enable to turn waveform

cycle recording on/off.

Press any Pre- or Post- trigger cycle

field. Use the numeric keypad to

enter the cycle counts for

corresponding rms sample/waveform

cycle capture.

RMS Summary (Cycles):

• Press Pre-Trigger to set the

number of cycles for Pre-event

start rms samples. This setting is

also used for Pre-event end cycles.

Use the keypad to enter the

number of cycles of rms samples

to record before the event start

trigger cycle.

• Press In-Out Post to set the

number of cycles for Post-event

start cycles. Use the keypad to

enter the number of cycles to

record after the event start cycle.

The maximum number of cycles to

record is 100 cycles.

• Press Out-In Post to set the

number of cycles for Post-event

end cycles. Use the keypad to

enter the number of cycles to

record after the event end point.

The maximum number of cycles to

record is 100 cycles.

MARK112_209

MARK112_212

1 2 ... 120 121 122 123 124 125 126 127 128 129 130 ... 273 274

Comentarios a estos manuales

Sin comentarios