Dranetz Visa Guía de usuario Pagina 220

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 274
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 219
C-4
Battery Pack Replacement
Battery Pack Replacement
Introduction
The PowerVisa contains an easily replaceable internal battery pack. See Appendix D
for ordering information.
WARNING
Replace with Dranetz-BMI NiMH battery pack BP-PX5 only.
ADVERTENCIA
Reemplace con batería Dranetz-BMI NiMH BP-PX5 solamente.
AVERTISSEMENT
Remplacer par la batterie Dranetz-BMI NiMH BP-PX5 exclusivement.
WARNUNG
Nur mit Dranetz-BMI NiMH BP-PX5 Batteriesatz auswechseln.
NOTE
During normal operation, the battery pack will be slightly warm to the touch.
Procedure
Follow these steps to replace the battery pack.
Continued on next page
Step Action
1 Press the PowerVisa power button to off.
2 Turn off power to the circuit being measured.
3 Disconnect voltage and current probes from the circuit and the
PowerVisa is rear panel.
4 On the bottom of the PowerVisa, push the tab to release the battery
cover. Refer to the diagram shown on page C-5.
5 Remove the cover.
6 Pull up on removal strap and remove battery pack.
7 Insert the new pack into the compartment making sure to observe
polarity markings.
8 Replace the cover and press down until it latches closed.
9 Discard the old battery pack in accordance with Environmental
Protection Agency (EPA) regulations.
10 Press the PowerVisa power button to on.
Vista de pagina 219
1 2 ... 215 216 217 218 219 220 221 222 223 224 225 ... 273 274

Comentarios a estos manuales

Sin comentarios