Dranetz Xplorer Guía de usuario descargar pdf (Pagina 192)

9-4

External Communication Interface, continued

Connection

setup via USB

The following procedure and diagram describe how to connect the PX5 to a computer

via USB. Once the physical connection is done, see Chapter 4 Instrument Settings -

Communications on page 4-10 for instructions on how to enable the PX5 settings to

communicate with external devices.

1. Connect one end of the fiber optic cable (P/N 900406) into the Fiber Optic Serial

Data Port located on the left side panel of the PX5.

2. Connect the other end of the fiber optic cable into the Fiber Optic Port on the plastic

housing of the 9-pin/RS232 Communication Module (P/N COMM-RS232).

3. Connect the 9-pin RS232 connector to the USB to RS232 Serial Adapter.

4. Install the software on the compact disc that came with your USB to RS232 Serial

Adapter. This will create a virtual COM port on your computer at the next available

serial port.

5. Connect the USB cable from a USB port on your computer to the USB socket of the

RS232 Serial Adapter.

6. Check the Device Manager in the Windows

control panel to identify the new COM

port number created by the USB - RS232 Serial device. Use this COM number to

connect the PX5 with NodeLink

7. Refer to the NodeLink

User’s Guide (P/N UG-NODELINK) for instructions on

how to set up a NodeLink site.

USB TO RS232

ADAPTER

DB9

TO PC

USB PORT

FIBER OPTIC CABLE

TO PX5

OPTICAL

PORT

RS232 - FIBER OPTIC

ADAPTER

1 2 ... 187 188 189 190 191 192 193 194 195 196 197 ... 289 290

Sin comentarios

Dranetz Xplorer Guía de usuario Pagina 192