
23
Dran-View 6 User Guide
5.1.1. Event List Tab Toolbar Commands detailed information
Event
Removal
This command will toggle removal mode for the Event List. While in removal
mode, this toolbar button will look like this . Checkboxes ( , or ) will
appear to the left of each item in the tree. The first time you enter removal mode,
it may take Dran-View some time to generate additional events. This is done so
that all samples will belong to an event.
While in removal mode, you may notice some events not otherwise visible, called
"Trend" and "Pre/Post Event". These are the generated events mentioned above.
Clicking a checkbox ( or ) next to an event will toggle the visibility of that
event and all samples belonging to it. Clicking the checkbox next to a branch of
any kind will toggle the visibility of all events and all samples descendant of that
branch. In addition to "On" ( ) and "Off" ( ), checkboxes next to branches may
have a third state, called "Tristate" ( ). This state indicates that some (not all)
descendants of that branch are visible.
Changes in event visibility will not take effect until you exit removal mode by
again pressing the Event Removal On/Off toolbar button. The checkboxes
should now disappear, and the toolbar button should revert to this appearance.
When disabling an event, that event will also disappear from the Event List, the
Event Box, each chart's event ruler, etc. If you wish to re-enable an event, simply
turn on the event removal again and click that event's checkbox.
To use an event removal more similar to that in Dran-View 5.x, right-click on the
Event List and select properties from the pop-up menu, then click the Event
Removal or Classic Event Removal tab. If the Event Removal appears, click the
Classic Mode checkbox at the bottom of the property page to view the classic
event removal.
Continued on the next page
Comentarios a estos manuales